Extron electronics EDID 101H 4K PLUS, Руководство пользователя

Страница: 29 / 35

Connecting to the USB Port
A female mini type- B USB Config port located on the front panel (see
Front Panel Features
on page 4) is used to connect to a host computer for configuration using SIS commands with
Extron DataViewer, for updating firmware with the Extron Firmware Loader utility and for using
PCS. DataViewer and Firmware Loader are available at
www.extron.com
. The programs are also
necessary to install the USB driver to the connected computer.
To connect the EDID 101H 4K PLUS to a host computer:
NOTES:
• If an Extron USB device has never been connected to the host computer, prior to
connecting the Config (USB) port for the first time, you must install and activate
the USB driver. The simplest way to do this is to install either Dataviewer (see
DataViewer on page 22) or the Firmware Loader utility (see Updating the
Firmware on page 23) .
• The wizard opens only on the first occasion you connect the EDID 101H 4K PLUS
to that USB port. The wizard reopens if you connect the EDID 101H 4K PLUS to
a different USB port or if you connect a different piece of equipment, requiring a
different driver, to the same USB port.
• Connect a USB A to mini B cable between the Config port on the front panel of the
EDID 101H 4K PLUS, and a USB port of the PC (see figure 16).
EDID 101H 4K PLUS
Extron
SIGNAL
HDCP
IN OUT
STORE
EDID
0
1
2
3 4 5 6 7
8
9
A
B
C D
E
F
CONFIG
WiFi
1 2 3 4
USB
Ports
PC
USB Cable
Type A
USB
Mini Type B
USB
Figure 16. Connecting a PC to the Front Panel USB Port
EDID 101H 4K PLUS • Reference Information 21