DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation
15
Secondary functions (
•
):
•
Select a global preset (see “
Saving and Recalling Presets
” on page
29
).
•
Output 1 only:
With the Input 1 button, places the switcher in I/O grouping
mode (see “
I/O Grouping
” on page
32
).
•
Mute and unmute an output (see “
Muting and Unmuting Video and Audio
Outputs
” on page
36
).
Configuration Port
c
Config port
— This RS-232 port is an alternative to the Remote RS232/RS422
connector on the DXP rear panel (see “
g
Remote RS232/RS422 connector
” on
page
9
for a description). The port (RS-232 only) can be used for system configuration
and control via SIS commands or the control software. To connect to the Config port,
see “
RS-232 Config port (front panel)
” on page
11
.
Control Buttons
The following table summarizes the primary and secondary functions of the four
control buttons.
Primary Functions
ENTER
PRESET
VIEW
ESC
Action:
Save changes.
Select preset
mode.
Select view
mode.
Cancel or
escape.
Indication:
Blink:
Save
needed
Blink:
Save preset.
Lit:
Recall preset.
View the selected
mode.
Blinks once.
Secondary Functions
I/O Grouping
Action/
indication:
Select group 1.
Select group 2.
Select group 3.
Select group 4.
Port
configuration
Action 1:
Select Configuration Mode
Action 2/
indication:
Select 9600 baud.
Blink:
Selected
Select 19200 baud.
Blink:
Selected
Select 38400
baud.
Blink:
Selected
Select 115200
baud.
Blink:
Selected
Front panel
locks
Action:
With Video and
Audio, select lock
mode 2 or toggle
between modes 0
and 2.
d
Enter button
— The Enter button does the following:
Primary functions (
❏
):
❏
Saves changes that you make on the front panel.
❏
Indicates that a potential tie has been created but not saved.
❏
Indicates that a global preset has been selected to be saved or recalled but that
the preset action has not been accomplished.
