Extron electronics DTP2 T 202 FB, Руководство пользователя

Страница: 9 / 40

DTP2 T 202 FB • Introduction 1
Introduction
• About this Guide
• About the Switching Transmitter
•
TP Cable Advantages
• Features
About this Guide
This guide describes how to install, operate, and configure the DTP2 T 202 FB, a floor
box-mounted, switching, twisted pair transmitter. The DTP2 T 202 FB outputs a signal to a
compatible DTP2 receiver, with a range of up 330 feet (100 M).
NOTE: In this guide, the DTP2 T 202 FB is commonly referred to as a “switcher,”
“transmitter,” or “switching transmitter.”
About the Switching Transmitter
The DTP2 T 202 FB is a 2-input HDMI and DisplayPort switcher with a DTP2 transmitter
output (see
figure 1 , on the next page). The switcher is HDCP compliant, and supports
2560x1600 @ 60 Hz and 4k/UHD @ 60 Hz signals.
The switcher selects between a DisplayPort and HDMI (or DVI video with the appropriate
adapter) inputs. The transmitter creates a proprietary digital signal consisting of one or more
of the following inputs:
• The selected digital video input, including embedded digital audio
• An optional analog audio input
•
Bidirectional RS-232 and infrared (IR) control signals
The switcher and a compatible receiver extend the usable distance of video, audio,
and control signals over a single Extron XTP DTP2 24 shielded twisted pair (STP) cable
(recommended) or Category (CAT) 5e, CAT 6, or CAT 6a STP cable.
The transmitter is compatible with all Extron DTP2 and DTP (legacy DTP) products. It has a
range of up 330 feet (100 meters).
The switcher fits into floor boxes from OBO Bettermann, MK by Honeywell, Electraplan, and
PUK.
The included external 12 VDC power supply accepts 100 to 240 VAC, 50-60 Hz to provide
worldwide power compatibility. A single power supply connected to either the transmitter or
the compatible receiver can power both units through the STP cable.
ATTENTION:
• Do NOT use the transmitter to remotely power a legacy DTP receiver. Circuit
damage to the receiver WILL result.
• NE PAS utiliser l’émetteur pour alimenter à distance un récepteur de la gamme
existante DTP. Cette opération FINIRA par endommager le circuit menant à le
récepteur.