Extron electronics DTP2 T 202 FB, Руководство пользователя

Страница: 26 / 40

DTP2 T 202 FB • Installation and Operation 18
HDMI connector
Use the LockIt Lacing Bracket, supplied with the switcher, to securely fasten the HDMI
cable to the switcher as follows (see figure 18).
3
1 1 1
3 3 3
2 2 2
5 5 5
4 4 4
Figure 18. Installing the LockIt Lacing Bracket
1. Plug the HDMI cable into the panel connection (
1
).
2. Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it (
2
). The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket (
3
).
ATTENTION:
• Do not overtighten the HDMI connector mounting screw. The shield to which it
fastens is very thin and can easily be stripped.
• Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket as shown (
4
).
5. While holding the connector securely against the lacing bracket, use pliers or similar
tools to tighten the tie wrap, then remove any excess length (
5
).
Operation
The DTP2 T 202 FB can be controlled only by SIS commands (see Simple Instruction Set
Control on page 21) or the Product Configuration Software (see Product Configuration
Software on page 28). This section contains basic information about operation details.
Indications
(Power) LED — Lights when power is applied.
HDMI
DP
SIGNAL
HDCP
AUTO
HDMI LED — Lights when an HDMI input signal is detected.
DP LED — Lights when a DisplayPort input signal is detected.
Signal LED — Lights to indicate when a signal is detected on the selected input.
HDCP LED — Lights when the HDMI input signal is encrypted.
Auto LED — Lights when the device is in auto switch mode.