9
Installing an optional ZipClip 100 or ZipClip 200 mounting kit
ZipClip 100
mounts
horizontally with the
push tab to the right.
ZipClip 200
mounts
vertically on the bottommost
mounting location with the push tab up.
Cable Cubby 1252 MS
Use the provided ZipClip screws
and washers to mount the ZipClip
to the Cable Cubby 1252 MS.
1
Installing an optional PMK 155 Product Mounting Kit
PMK 155
Mount the device (up to 1.75 inch [44.4 mm] tall) and power supply to the PMK 155 (see the
PMK 155 Installation Guide)
.
1
Install the two supplied Allen bolts from the
PMK 155 kit to the shelf leaving approximately
1/8 inch (4 mm) protruding.
2
Slide the shelf sideways horizontally onto the
Cable Cubby mounting bracket from the front
of the enclosure, on either the left or right side,
until the shelf drops into the slot in the bracket.
3
Tighten the bolts with a 4 mm Allen wrench.
4
5
Dress the cables associated with the device
installed on the shelf using tie wraps.
Connect cables to the system.
NOTE
: The pipe clamp that is included with the PMK 155 is not
required for the Cable Cubby installation and can be discarded.
Side view with bracket
