7
Step 1 — Perform height adjustment
NOTE:
If the lid is the same thickness as the table, proceed to
on page 8.
If the lid thickness is different than the table
thickness, loosen, but do not remove, the
wing bolts (two on each side), just enough
to allow the Cable Cubby to slide up and
down in the brackets.
Raise the unit up or down until the lid is flush with
the table top surface. Use an assistant if necessary.
1
Firmly tighten the wing bolts.
3
2
NOTE
: If the lid is thinner than the table
surface, it may be necessary to relocate
the wing bolts to the bottom position of
the Cable Cubby.
