Extreme Networks ExtremeWare 7.2e, Инструкция по установке и эксплуатации

Страница: 45 / 344

Installing Optional Features
ExtremeWare 7.2e Installation and User Guide 45
9
Using the supplied cable, connect the AC cable to the AC supply for each unit. For countries other
than the USA, you might require a different AC cable that is not supplied. Contact your sales
representative for the appropriate cable type and for information regarding the voltage and current
requirements of the power supply.
The PSU-E LED on the front of the EPS-160 should be solid green to indicate that it is ready. Table 3
on page 23 shows all the indicators for the power supply.
Adding a second EPS-160 to the EPS-T
To install an individual EPS-160 into the EPS-T:
1 Remove the EPS-160 from the packing material.
2
Insert the EPS-160 into the front of the EPS-T.
3 Tighten the provided thumbscrews to secure the power supply to the tray.
4 Follows steps 7 through 9 on page 43.
Removing an EPS-160 from the EPS-T
To remove an EPS-160 from an EPS-T:
1 Disconnect the AC by removing the plug from the wall
2
Disconnect the AC power cord from the EPS-160.
3 Remove the redundant power cable from the EPS-160.
4 Loosen the thumbscrews on the front of the tray and slide the EPS out of the EPS-T.