Figure 37: Inserting the cable wires into the DC terminal connector
a. Slide the end of the ground wire into the ground terminal (labeled GND on the left side of the
connector.
b. Tighten the screw on the top of the ground terminal connector to 2.2 in
‑
lb (0.25 N m).
c. Slide the end of the negative wire (–48 V) into the negative terminal (labeled –, in the middle of
the terminal connector).
d. Tighten the screw on the top of the ground terminal connector to 2.2 in
‑
lb (0.25 N m).
e. Slide the end of the positive wire (–48 V RTN) into the positive terminal (l, on the right
side of the terminal connector).
f. Tighten the screw on the top of the ground terminal connector to 2.2 in
‑
lb (0.25 N m).
6. Insert the connector into the slot on the power supply.
Connect DC Power
Install Your Switch
62
ExtremeSwitching 5320 Series Hardware Installation Guide
