Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
•
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
2
) minimum; over 6 feet, the
minimum wire size is 16 AWG (1.0 mm
2
).
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/
Console Connector Pinouts
describes the pinouts for a DB-9 console plug connector.
Table 33: Pinouts for the DB-9 Console Connector
Function
Pin Number
Direction
DCD (data carrier detect)
1
In
RXD (receive data)
2
In
TXD (transmit data)
3
Out
DTR (data terminal ready)
4
Out
GND (ground)
5
-
DSR (data set ready)
6
In
RTS (request to send)
7
Out
CTS (clear to send)
8
In
shows the pinouts for a 9-pin to 25-pin (RS-232) null-modem cable.
Technical Specifications
Console Connector Pinouts
ExtremeSwitching 5320 Series Hardware Installation Guide
79