7
2. Install the control horns for the ailerons. ***PLEASE NOTE*** There are
2 different size control horns for the ailerons. The 2 longer sets are for the
outboard aileron servos, the 2 shorter sets are for the inboard locations. Pay
very close attention when separating and grouping the horns to be sure you
are gluing the correct horns in the correct location!
Insert the horns into the base plate and then temporarily install them in the
aileron. Trace around the base plate with a fine tipped felt marker and then
remove the horn and base plate. Use a sharp hobby knife to cut 2mm inside
the line you marked and remove the covering. Scuff the bottom portion of the
control horn that inserts into the hole in the control surface. Use epoxy to
secure the control horns in place. Follow the same process to install the
elevator control horns in the designated locations.
