Extreme Flight 104 Laser EXP ARF, Инструкция по сборке

Страница: 27 / 30

Figure 34
Final Items
This completes the basic assembly of the Laser. However there are still things to consider, for
example a prop and spinner. If using the DA120 we find the Falcon
27X11/28X9.5/28X10/29X9 to all be very good prop choices. The spinner we used is a 5” red
carbon fiber, the spinner and props are available thru Extreme Flight RC.
The rudder/elevators/wings/canopy are all removable items, be sure to check them and make
sure all connections are made. The rudder is secured by the long hinge pin and is discussed in
the rudder section. The elevators have 2-3mm bolts that secure them as well as 2 small carbon
fiber tubes. The wings have one large carbon fiber tube and each panel is secured by 2-4mm
bolts just inside the fuselage. The canopy has two small protrusions or fingers on the front
side that slide into pockets behind the cowling and then 2-3mm bolts that secure in near the
rear of the canopy and screw into the side of the fuselage. We recommend using the Extreme
Flight anodized cone washers, they provide a secure fit and really add a nice look to your
model.