Extreme Flight 104 Laser EXP ARF, Инструкция по сборке

Страница: 22 / 30

Figure 26
If you prefer a tuned pipe or canister installation then laser cut piece of plywood is cut
and provided to make this easier. It also includes silicon tubing to secure your desired
exhaust system. Also 70mm drop headers are needed to reach your pipes. We strongly
suggest trial fitting your exhaust before beginning the final installation. Once you are
happy with the trial fit, begin by screwing (you can also glue them) the laser plywood
into the fuselage bottom to the formers to support your pipes/canisters, then position the
tubing in between the various notches and this will support your system. Refer to figures
27, 28 and 29. You will also need to determine how your system will exit the bottom of
the fuselage and cut accordingly.
Figure 27