MA410T-EU-EN-V1.0-7/12
7
Capacitance Measurements
WARNING:
To avoid electric shock, discharge the capacitor before measuring.
1. Rotate the function switch to the
CAP
capacitance
position.
2.
Insert the black test lead banana plug into the negative
COM
jack.
Insert the red test lead banana plug into the positive
jack.
3.
Touch the black test probe tip to one side of the device.
Touch the red test probe tip to the other side of the device.
4. Read the capacitance value in the display.
Type K Temperature Measurements
1.
Rotate the function switch to the
°F or °C
temperature
position.
2. Insert the Temperature Probe into the input jacks.
3. Place the temperature probe tip(s) where needed.
4. Read the temperature on the display.
Note:
In case of an open input or a temperature overrange, the meter will display
“OL” .
Data Hold
To freeze the LCD reading, press the
HOLD
button. The
HOLD
icon appears on
the LCD. Press the
HOLD
button again to return to normal operation.
Relative
Press the
REL
button (
REL
will appear in the display) to zero the reading and create a reference
point. All future reading will be the difference between the actual reading and the stored “REL”
reading. In the REL mode, autoranging is disabled and measurements are limited to the range
active when the
REL
button was pressed. Press the REL button to exit the mode.
Note: Relative does not function in Frequency or Duty Cycle mode.
Automatic Power Off
In order to conserve battery life, the meter will automatically turn off after approximately 30 minutes.
To turn the meter on again, change the position of the function switch.
Low battery indication
When the
icon appears in the display, the battery should be replaced. Refer to the battery
replacement procedure in the maintenance section.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
