![background image](http://html1.mh-extra.com/html/extech-instruments/andes-3/andes-3_user-manual_2453639009.webp)
Do not use a charger not approved by Extech for use with the ANDES 3.
Use of an unapproved charger could damage the battery pack or the
printer and will void the warranty.
The battery terminals are well recessed inside the printer. Do not allow
them to contact conductive material since this may create a short circuit
which could cause injury or start a fire.
When using the wall mounted charger ensure the socket outlet is close to
the printer and easily accessible during the battery recharging process.
Either switch the socket off (if supplied with a socket switch) or pull out
the charger from the socket or disconnect the plug from the printer in the
event of any problems.
1.3 Reading the LED Status
The illustration below points out the location of the LED indicators described in Table 1.
FIGURE 4 – LED INDICATOR LOCATIONS
Note: Refer to the Troubleshooting guide to determine error or fault condition.
Table 1 explains the LED indicator status. Refer to Figure 4 for the locations described for
ON/OFF and FEED pushbutton switches and AC adaptor socket
ANDES3 User’s Guide
Rev 1.0
9