www.exposurelights.com
9
Smart Charging Exposure Lights
Before using your Exposure Light please charge it fully.
Use only genuine Exposure Lights chargers. International chargers are
available, also in-car charger and USB top-up cable.
EXPOSURE LIGHTS use the highest quality Lithium Ion batteries. This
allows them to be recharged at any point during the discharge cycle. Burn
times will not be affected by multiple re-charging.
Re-charging instructions
• Ensure the light unit is turned off.
• Plug the Smart Charger into the power supply and switch on the
supply. The LED on the charger will show green (operational).
• Insert the charger connection plug into the light’s charge port, located
on the back of the light. The charger’s LED will show red when the light
unit is charging up to 90% full.
The function button on the light will continuously flash green to inform you
that the charger is connected and functioning.
From empty the light
unit will rapid charge
to approximately 90%
capacity - at this point the
LED on the charger will go
from red to green.
To 100% charge the light
leave the charger plugged in
and turned on for a further 1 to
4 hours depending on the model (see
below). You can leave the light on charge as long as you like (like your
mobile phone).
charge port
function button
Rapid (red)
Trickle (green)
90%
Final 10%
Joystick
3 Hrs
1 Hrs
Diablo
3 Hrs
1 Hrs
Race
6 Hrs
2 Hrs
Strada
6 Hrs
2 Hrs
Toro
9 Hrs
3 Hrs
MaXx-D
12 Hrs
4 Hrs
Charge Capacity
Long periods of non-use will lower the voltage of the battery. If the unit
is being stored for long periods, please ensure the battery is periodically
charged. We suggest once per month.
All the Exposure Lights from 2008 (MaXx range) and 2009 (MaXx-2 range)
and 2010 use the same Smart chargers.