INSTALL THE WINDOWS NT 4.0 DEVICE DRIVER
Currently there is no Plug and Play support for the Windows NT 4.0, User
need to insert the HD PC Card while the power is off. Restart the computer
and click on My Computer , then Control Panel, choose SCSI Adapters.
Choose Drivers tab and the click on Add.. From the Install Driver click
Have Disk
Install from disk will prompt for a diskette to install the driver, using Browse
button or type in the path A:\winnt finishing the installation then you need to
restart the computer.
After computer boot up go to My Computer icon you should have an addition
hard disk icon.
GAME PORT CALIBRATION
The game port on the HD Traveler requires I/O address 200 to 207. Not all
the notebooks have this I/O available, please check APPENDIX A for the
incompatible list of notebooks. If your notebook is compatible with the game
port and you already installed the necessary driver for the game port, you
will need to calibrate your joystick (or game-pad) before you use it. To check
if the game port is functioning correctly, first make sure you connected the
joystick or game-pad) to the game port firmly and then do the following
steps-
Calibration Under DOS Mode
Most of the game programs offer a calibration utility allow you to calibrate
your joystick.
Joystick Calibration Under Windows 95
Select “Control Panel” from “My Computer”, and then select “Joystick”. Click
on calibrate and follow the on-screen instructions to finish the joystick
calibration. You can test the calibration result by clicking the “Test” button
and running the testing procedure.
