Maintenance by the user
49
GB
10.2
Cleaning the steam shower
DANGER! Risk of burn injuries
~
The steam shower must be properly inserted before treatment can begin!
Without the steam shower mounted, hot steam escapes during operation.
Removing the steam shower
1. Remove steam shower from holder and release.
2. Rotate the steam shower towards the edge of the steam dome.
3. Carefully shift the end section of the steam shower over the edge of the
steam dome and remove the steam shower.
4. Clean the steam shower with a soft brush and thoroughly rinse it out.
Checking seals
1. Check seals for cracks or damage.
-
In the event of dirt or damage, clean or replace the seals.
2. Check that the seals fit securely: the 2 round seals need to be sitting in the
grooves.
3. The shaped seal must be in contact with the small opening in the steam
shower. The large opening faces away from the steam shower.
Inserting the steam shower
The steam outlets of the steam shower must be pointed downwards. The two
pins then fit perfectly into the guides.
1. Insert steam shower into the steam dome.
2. Shift the end section of the steam shower over the edge of the steam dome.
3. Rotate the steam shower horizontally and slide it into the holder until it
stops. The pins of the steam shower must sit in the two guides.
4. Check that the steam shower is securely in place before commencing the
treatment.
Edge of steam dome
Pins
Guides
Holder
Steam shower
2 round seals
Shaped seal
Holder
2 round seals
Side view of seals
Shaped seal
Holder
Steam shower
__P71.book Seite 49 Freitag, 5. November 2021 9:42 09