Exodraft RHG, Руководство пользователя

Страница: 13 / 28

UK | 13
3112005_RHG_UK
Installation onto a brick chimney
If the fan is to be fitted on a brick chimney, please use the location brackets. See the installation guide
below.
Step Action Illustration
1
Measure the inside diameter of the brick chimney.
Then cut a hole in the mineral wool mat that
matches.
Note that there must always be a minimum of
20 mm of mat surface at any point around the
circumference of the hole.
20 mm
2
Fit the location brackets in the grooves on the
underside of the bottom section and fasten using
the nuts and bolts supplied.
Please note that the bolts must be inserted from
beneath.
RHG
3
Adjust the distance between the location brackets
to fit the inside diameter of the chimney, and then
tighten the nuts. Note that there should be a 2-4
mm gap between the brackets and the chimney
so as to avoid transmitting vibrations from the fan
to the chimney
A and B measurements: please refer to step 1.
RHG