Exmark VANTAGE X Series, Руководство оператора

Страница: 39 / 60

Maintenance
Figure 23
1. Rear lift points 2. Engine deck brackets
7. To raise the front of the mowing deck, tighten the
front locking nuts by the same amount on both
front adjusting rods. Tighten both rear locking
nuts. Check the side to side level of the mower
again; refer to
Deck Leveling .
Note:
Rake adjustments may affect the neutral
position. See the Neutral Adjustment section in
Maintenance.
Adjusting the Rear of the
Deck
1. Park the machine on a level surface and disengage
the blade control switch.
2. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
3. Check the air pressure in the drive tires. If needed,
adjust to the recommended inflation; refer to
Checking the Tire Pressure in Drive System
Maintenance section.
4. Set the height of cut to the 3 inch (7.6 cm)
position.
5. Carefully rotate the blades front to rear. Measure
from the tip of the front blade to the level surface.
The blades should measure 3 inches (7.6 cm).
6. If it does not measure correctly, locate the
height-of-cut rod on the right side of the machine
(see Figure 24).
Figure 24
1. Adjustment screw
7. Turn the adjustment screw until the blade tips
match 3 inches (7.6 cm).
Pump Drive Belt Tension
Self-tensioning - No adjustment necessary.
Mower Deck Drive Belt
Tension
Self-tensioning - No adjustment necessary.
Check the Park Brake
1. Park the machine on a level surface.
2. Shut off engine and wait for all moving parts to
stop.
3. When the park brake is released, the brake bars
should lift off the tires and the hand lever should
travel forward to the end of the slot in the control
panel. When engaging the brake, the hand lever
should travel 3/4 inch (19 mm) at the control
panel slot when the brake bars first contact the
tire. Measure the gap from the front of the lever
to the end of the slot in the control panel when
the brake bar contacts the tire.
Park Brake Adjustment
If the parking brake does not hold securely, an
adjustment is required.
1. Park the machine on a level surface.
2. Shut off engine and wait for all moving parts to
stop.
3. Check the air pressure in the drive tires. If needed,
adjust to the recommended inflation; refer to
39