EXFO bv10, Руководство пользователя, Страница: 38 / 116

Introducing the BV10 CLI
32
BV10
Connecting to the BV10 to a Console
TEST Port
In-band management activities on the TEST port is provided for basic
configuration and software upgrade tasks in situations where the
Management port is inaccessible.
It is important to note that in-band management through the TEST port
should be performed with low traffic volume so that management
responses have minimal impact on test traffic. With high traffic volume,
management responses might add jitter/latency or dropped packets to
results. When a CLI session is opened on the TEST port, the following
warning message appears:
WARNING: Session opened on the TEST Port. Any action may interfere with traffic.
Not all CLI commands are available on the TEST port.
The
console in-band enable|disable
command controls in-band management on
the test port. By default, in-band management on the test port is enabled.
Refer to
console in-band enable|disable on page 62 for more information.
To use the TEST port:
1.
Ensure that both your PC network interface and the BV10‘s TEST port
are connected to the same Management network. Refer to
Connecting
the TEST Port Interface
on page 16.
2.
On your PC, run a terminal application.
3. Select Telnet or SSH connection type.
The use of Telnet server is enabled by default on the BV10.
The use of SSH server is disabled by default on the BV10 and must be
enabled as well as the password must be defined; refer respectively to
console telnet|ssh server enable|disable
on page 61 and
password set
password on page 61; the user name is exfo . The CLI supports SSHv2.
Encryption keys are factory generated.
4. Enter the BV10 TEST port IP address and Netmask.
5.
Establish the connection with the BV10.