12
ASSEMBLY
STEP 3
3a. Removing The Hardware From The Front Post
–
Remove four
Bolts (23)
and four
Curve
Washers (25)
from the
Front Main Frame (5).
Slide the
Front Handlebar Post Cover (74)
up to the
Front Handlebar Post (6)
.Insert the
Tension Cable (40)
through into the bottom
hole of
Front Handlebar Post (6)
and pull it out from the square hole of
Front Handlebar
Post (6).
3b. Connecting The Console Wires
–
Connect the
Sensor Wire (61)
and
Extension Hand
Pulse Sensor Wires (65)
from the
Front Main Frame (5)
to the
Extension Sensor Wire (64)
and
Extension Wires (63)
from the
Front Handlebar Post (6).
3c. Installing The Front Post
–
Insert the
Front Handlebar Post (6)
onto the tube of the
Front Main Frame (5)
and secure with four
Bolts (23)
and four
Curve Washers (25)
that were
removed. Slide the
Front Handlebar Post Cover (74)
down to the
Front Main Frame (5).
Remove the
Bolt (36)
and
Big Curve Washer (38)
from the
Tension Control Knob (14).
3d. Installing the Tenshion Control Knob
-- Put the cable end of resistance cable of
Tension
Control Knob (14)
into the spring hook of
Tension Cable (40)
as shown in
drawing A.
Pull
the resistance cable of
Tension Control Knob(14)
up and force it into the gap of metal bracket
of
Tension Cable (40)
and gently remove the
Clip (80)
after well-connected the resistance
cable of
Tension Control Knob (14)
and
Tension Cable (40)
as shown in
drawing B.
Attach
the
Tension Control Knob (14)
onto the
Front Handlebar Post (6)
with the
Bolt (36)
and
Big
Curve Washer (38)
that were removed.
6 mm Allen Wrench
Tool:
!
Multi Hex Tool with Phillips
Screwdriver
MUST TIGHTEN IN
SEQUENCE:
A,B,C,D.
A
B
C
D
Содержание 900XL
Страница 5: ...3 LABEL PLACEMENT...
Страница 8: ...6 OVERVIEW DRAWING...
Страница 11: ...9 HARDWARE TOOLS PACK...
