EXCELL PRECISION CO., LTD.
0201813X
ZSME300000366
9
Preset Single point (preset low limit only):
After “preset low limit” procedures is completed and the display shows
.
,
then press
key again, the display shows
.
. This means that the
“preset
single point” procedure is completed.
NOTE
_ _ _
x
x
A
B
A
Setting for the status that LCD is on and the beeper beep:
0 = when stable, the beeper beeps and LCD is on.
1 = when stable, the beeper beeps; whether stable or not, LCD is on.
2 = whether stable or not, the beeper beeps and LCD is on.
3 = open warning device: when the weight is higher than HI value and the weight is
stable, LCD is on and Relay Card open.
B
Setting for the beep status:
0 = No beep
1 = OK (when the weight is over Low Limit & under or equal to High Limit.), the beeper
beeps.
2 = When the weight is under or equal to Low Limit & over High Limit, the beeper beeps.
Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
When over “Low Limit”, the beeper beeps and
is off
Whether stable or not, the beeper beeps and LCD indication is on
Warning device setting
(not available in 4/5 key models)
Set HI value and value of the beep, LCD mode should be fixed as follows:
A
When the weight equals to HI value, Relay Card open and the weight is accumulated. Press CE
key to dismiss the warning sound and the range of accumulated weight is [000.000]~[999999
].
Clear warning accumulation
(not available in 4/5 key models)
Press
key first and then press
key to clear all accumulated data.
Accumulated data is cleared automatically under following conditions
a. when shift among weight mode, counting mode and warning accumulation mode.
b. when shift the units
c. turn off the scale
Set relay low output: L1 => low output; L0=> no low output
LCD indication:
10d Low Limit High Limit
◆
To exit preset mode, please press key.
2. Recall Check-weighing Values
(not available in 4/5/10 key models)
Press
key then press
key
Recall
“Low limit value”
Then press
key again
Recall
“High limit value”
Then press
key again
Recall
“Beeper value”
Then press
key again
Back to the beginning
Содержание AWH3
Страница 28: ......
