Page - 13
Arming Bypass: Upon arming, if any protected circuit is inoperable, that circuit will be
bypassed. For example, if the trunk is left open, you can still arm the system normally from the
transmitter. The arming confirmation will, however change from one siren chirp (or horn honk)
to three honks and light flashes. During Arming Bypass, the Digital Status Indicator will
display which circuit is bypassed. The bypassed circuit will automatically be reinstated for
protection 5 seconds after that circuit becomes operative, i.e., the trunk is closed. When a
triggered circuit is in a bypassed state, all other operating circuits will be protected normally.
Silent Arming and Disarming: Upon arming or disarming, if the confirmation siren chirps
(or horn honks) are not desired, simply press and release the transmitter's small center button
before pressing and releasing the large button.
Sensor Bypass: Your Excalibur Gold system provides you with the convenient option of
temporarily deactivating the Auxiliary Sensor without affecting any other trigger circuit. To
deactivate the Auxiliary Sensor, simply press and release the small lower transmitter button
within 3 seconds after pressing the large transmitter button when arming the system. You will
hear a second siren chirp (or horn honk), confirming the security system has armed without
the sensor circuit protecting the vehicle. The next time you arm the security system, the system
will reset to its normal condition, and the Auxiliary Sensor will again be part of your protection.
If desired, a second Auxiliary Sensor may be easily added to your system.
You may program your Excalibur Gold security system to automatically arm and, if desired,
also lock the doors. This feature is described in the following section. Automatic
Rearming is another method whereby the system can become armed. This is a Programmable
Feature, which may be configured to operate if desired, and is described on Page 15.
Automatic Last Door Arming: Your security system can be programmed to arm automati-
cally when the vehicle's last door is closed. The moment the last door closes the siren will chirp
once (or the horn will honk once), the parking lights and dome lights will flash once and the
Visual Deterrent LED will begin to flash rapidly. Thirty seconds later the siren will chirp again
(or the horn will again honk once), the lights will flash once, the doors will lock (if the Last Door
Lock feature has also been chosen) and 3 seconds later the Visual Deterrent LED will slow
to a steady flash, confirming that the security system is fully armed. During this 30 second
period, the Digital Status Indicator will show " ", and then change to " " for ten seconds
when fully armed. However, if a point of entry is reopened before the single siren chirp (or horn
honk) and light flash at 30 seconds, this passive arming process stops, and will reset to start
over again when that point of entry is reclosed.
"Automatic Last Door Arming" offers a high level of security, since it does not require you
to remember to arm the security system when you leave your vehicle. Additionally, Automatic
Last Door Arming may entitle you to an insurance discount. Please note that the previously
described Arming Bypass feature does not operate with Automatic Last Door Arming. The
Arming Bypass is designed to operate only when arming from the transmitter, because all
protected entries must be closed prior to the Automatic Last Door Arming sequence to start.
Page - 14
Passive System Arming And Rearming
Page - 15
To prevent the system from automatically arming while the vehicle is being refueled you
should put the system in Valet Mode, keep your door open. We do not recommend leaving
your ignition key turned "on". Last Door Arming does not effect the operation or use of the
transmitter to arm the system - if desired, the transmitter may still be used to arm the system
at any time.
Automatic Rearming:
Selecting this feature adds Automatic Rearming, which is
independent of Automatic Last Door Arming. This feature will cause the system to
automatically rearm itself 90 seconds after disarming, unless the ignition switch is turned "on".
This prevents the accidental disarming of the system by the inadvertent pressing of the
transmitter's button while placing it in a purse or pocket. If the "Automatic Relocking"
Programmable Feature is utilized, the doors will also lock when the system automatically
rearms. Automatic Rearming is indicated by a fast flashing Visual Deterrent LED during the
90 seconds, then a parking and dome light flash when the system rearms.
Remote Valet: This Feature, which operates as part of the Automatic Rearming Feature,
will temporarily cancel the Automatic Rearming. To use Remote Valet, press and release the
small lower transmitter button within 3 seconds after pressing the large transmitter button
when disarming the system. The parking lights will flash on and off, and the LED Status
Indicator will illuminate steady to confirm Remote Valet operation. The system will remain in
Remote Valet mode until armed again by the transmitter; or, the Valet Switch may be pressed.
Page - 16
Security System Armed And Activated
While the security system is armed, the Visual Deterrent LED will be flashing. Should any
intrusion attempt occur, your system will instantly activate, or "trigger". Once triggered, the
system will:
1)
Sound the electronic siren or the vehicle's horn. The siren features six different tones,
and every 5 seconds the siren will change the tone to generate more attention to the
vehicle. The horn will sound a series of honks, sounding for one second, then pausing
one second. Every ten seconds, the horn honking will pause completely for 5
seconds, which avoids overheating the horn. This will occur for the duration of the
activated cycle.
2)
The exterior lights will flash.
3)
The doors will relock. This feature is so unique that the security system monitors the
status of the door and, if open, the system waits until the door is closed, at which time
it relocks the doors, so that the thief cannot easily regain entry.
The siren (or horn) and the parking lights will stay active for 60 seconds, or, unless you
disarm the system with the transmitter or by using the Valet Override. If all protected entries
are secure at the end of 60 seconds, the system will stop and rearm automatically to detect
another entry attempt. If there is a protected entry still open, or an optional sensor still in a
triggered state at the end of 60 seconds, the system will reactivate for two more 60 second
