Excalibur AL-2060-EDPB, Руководство по эксплуатации

Страница: 6 / 28

6
Controller & Transmitter Functions (cont’d)
TRUNK RELEASE / CHANNEL 2: Press the “TRUNK” button for 3
seconds�
• THE SYSTEM WILL DISARM AND THE TRUNK WILL
OPEN (IF EQUIPPED)�
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL PLAY THE TRUNK
RELEASE ANIMATION AND BEEP TWICE
(1-WAY TRANSMITTER: PRESS AND HOLD THE TRUNK
BUTTON FOR 3 SECONDS)
REMOTE START: Press and release the “ ” button twice within 5
seconds� (see user feature #8 for additional options)
• THE PARKING LIGHTS WILL FLASH ONCE AND THE
STATUS LIGHT WILL FLASH RAPIDLY�
• THE SYSTEM WILL TURN ON THE IGNITIONS AND
PROCEED TO START THE ENGINE�
• ONCE THE ENGINE IS RUNNING, THE PARKING
LIGHTS WILL FLASH AND THE STATUS LIGHTS WILL
FLASH SLOWLY�
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL PLAY THE REMOTE
START ANIMATION AND PLAY A MELODY�
• THE CLOCK WILL CHANGE TO 0:00 TO START THE
REMOTE START TIMER� IT WILL TIME HOW LONG THE
ENGINE RUNS IN MINUTES & HOURS�
( 1-WAY TRANSMITTER: PRESS THE START BUTTON
TWICE IN 5 SECONDS)
*
• If the engine stalls, the system will make up to 3 more attempts�
• Each time you park your vehicle, set the climate controls to give you the de-
sired interior temperature when you use the remote start�
The engine will run for the preset run time (see user feature #1)�
• Run Time Extender : Press the “ ” button one time while in remote start
mode to restart the engine run timer� The timer on the controller will restart at
“0:00”�
NOTE: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
• If you decide not to drive your vehicle, you can turn off the remote start using
the same method to turn it on (Default = press “start” twice in 5 seconds)
NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
• Upon entering the vehicle during remote start mode, turn the ignition key to
the “ON/RUN” position ( NOT START!! )� When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over�
*
x2