Excalibur AL-2060-EDPB, Руководство по эксплуатации

Страница: 24 / 28

24
Installer Programmable Features (cont’d)
Feature #5 - Light Relay Function
Dome Light Output (press “ lock ” button to program) - DEFAULT
Start (press “ unlock ” button to program)
Ignition Output (press “ trunk ” button to program)
Accessory Output (press “ start ” button to program)
Status (press “ lock ” & “ unlock ” button to program)
The system has two built-in relays, which can be programmed to perform several different func-
tions� The primary function of this relay, is to operate the vehicle’s dome, or interior lighting as
part of the system’s operations� Optionally, if desired or needed, this relay can be programmed for
the other functions listed above�
Feature #7 - Starter Cranking Time
0.75 Second (press “ lock ” button to program) - DEFAULT
1.00 Second (press “ unlock ” button to program)
1.5 Seconds (press “ trunk ” button to program)
2.25 Seconds (press “ start ” button to program)
This feature determines the crank time of the 1st start attempt when in “Tachless” mode� If the
engine doesn’t start on the first attempt, it will retry up to 3 more times extending the crank time by
an additional 0�2 second with each attempt��
Feature #8 - Door Lock/Unlock Outputs
0.8 Second Outputs (press “ lock ” button to program) - DEFAULT
3 Second Outputs (press “ unlock ” button to program)
Double Pulse Unlock Output (press “ trunk ” button to program)
Total Closure Lock Output (press “ start ” button to program)
This changes the system’s doorlocking outputs to suite different vehicle requirements� The total
closure setting provides a 28 second lock pulse (press LOCK or UNLOCK is during the pulse to
stop it) and a 0�8 second unlock pulse�
Feature #9 Remote Start Lock Control
Off (press “ lock ” button to program) - DEFAULT
Lock After Start (press “ unlock ” button to program)
Unlock before start (press “ trunk ” button to program)
Unlock Before RS & Lock After RS (press “ start ” button to program)
This feature allows for OEM alarm/lock control in relation to remote start operations thus eliminat-
ing extra wiring for OEM alarm control.
Feature #6 Blue Satellite Port, Blue Wire Function
Ignition
(press “
lock
” button to program)
Status / GWR (press “ unlock ” button to program) - DEFAULT
Defrost Pulse
(press “
trunk
” button to program)
Pulse After Engine Off (press “ start ” button to program)
Horn
(press “
lock
” & “
unlock
” button to program)
This determines the function of the Blue wire on the Blue satellite relay port�
The Status setting turns on briefly before the Ignition output and stays on during remote start
mode� The other pulse settings give a 0�8 second pulse under the selected condition� Defrost
Pulse
will send a pulse after start only when the cabin temperature is below freezing (32 degrees
F / 0 degrees C)�