10
Safety, Operation
Extension cords
An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety.
The
smaller the gauge number of the wire, the greater
the capacity of the cable, that is 16 gauge has more
capacity than 18 gauge. An undersized cord will
cause a drop in line voltage resulting in loss of
power and overheating. When using more than one
extension to make up the total length, be sure each
individual extension contains at least the minimum
wire size. The following table shows the correct size
to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier
the cord.(see page 4).
Motor
Be sure your power supply agrees with nameplate
marking. As little as 10% lower voltage can cause
loss of power and can result in overheating. All
Exact Tools products are factory-tested; if this tool
does not operate, check the power supply.
WARNING: Accessories must be rated
for at least the speed recommended on
the tool warning label. Accessories running over
rated speed can fly apart and cause injury
.
Accessory ratings must always be above tool speed
as shown on tool nameplate.
DANGER: Avoid contact with the blade
teeth to prevent personal injury
Functional Description
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Intended Use
PipeCut 220E:
The PipeCut 220E pipe saw is intended for use as
a pipe fitter’s tool at the installation site. The PipeCut
220E pipe saw can only be used to cut round pipes,
with a diameter of 0.6”-8.6” (15-220mm) and a
maximum wall thickness of 0,23” (6 mm) with steel
and other ferrous and non-ferrous materials and
0,55” (14 mm) with plastics. The PipeCut 220E pipe
saw can be used to cut all normal pipe materials,
such as steel, stainless steel, cast iron, copper,
aluminium and plastic. PipeCut 220E pipe saw is
intended for short, intermittent use. The machine
may be loaded for 2.5 minutes during a 10-minute
period (S3 25 %). PipeCut 220E pipe saw is not
intended for use in industrial production. Use pipe
holders to support pipe.
Product Features
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
This page is folded under the cover of this manual
(page 3). The following numbering of the product
features refers to this illustration.
1.
UNLOCK button
2.
Power switch
3.
Power-switch locking lever
4.
Blade-guard cover
5.
Moving blade-guard
6.
Edge of moving blade-guard
7.
Braking wheels
8.
Adjusting wheel
9.
Operating handle
10.
Blade-guard screw
11.
Spindle-lock button
12.
Motor unit
13.
Blade key and (key for the
adjusting wheel)
14.
Rating plate
15.
Overload protection or rpm
regulator
16.
Gripper unit
17.
Gripper adjustment handle
e n g l i s h
