eXact PipeCut 220 Pro Series, Руководство по эксплуатации

Страница: 12 / 20

Operation English
11
Piercing the pipe wall
Hold the pipe saw operating handle firmly with your
right hand and place your left foot on top of the pipe
approximately 50 cm from the pipe saw.
To start the motor, release the power-switch locking
lever first (FIGURE D/1) and push the power switch all
the way in (FIGURE D/2). Before starting to saw, wait
until the blade reaches full speed.
Pierce the pipe wall by pressing pipe saw operating
handle downwards slowly and steadily until the blade
has cut through the pipe wall (during piercing the pipe
must not rotate).
Look at the UNLOCK SWITCH during the piercing
operation. The yellow mark on UNLOCK SWITCH
disappears (FIGURE E / 1-2) when the pipe saw is
locked in the sawing position.
Now the motor unit is locked in the sawing position
(FIGURE F / 1) and you can safely start cutting around
the pipe.
Cutting around the pipe
Start cutting by feeding the pipe saw forward and at the
same time preventing the pipe from turning, for
example with your left foot (FIGURE F / 2). Feed the
pipe saw forwards for convenient distance.
Release the pipe (remove your left foot from the pipe)
and pull the pipe saw backwards. The gripping unit will
rotate the pipe backwards with the pipe saw.
FIGURE D
FIGURE E
FIGURE F
FIGURE G