eXact PipeCut 220 Pro Series, Руководство по эксплуатации

Страница: 11 / 20

Operation English
10
Exact PipeCut 220 Pro Series pipe cutting system operation instructions
Before operating the tool
- Ensure that motor unit is in the upright position.
- Check that the disc is correctly fitted, in good
condition and suitable for the material to be cut.
- Ensure the pipe saw guide wheels rotate.
- Ensure the support wheels rotate.
- Check the operation of the lower blade guard.
- Ensure the pipe is empty.
Connection to the mains power supply
Ensure that the mains voltage is the same as indicated
on the rating plate (FIGURE A / 13). Connect the pipe
saw to the power outlet only after having checked the
above points first.
Setting the pipe on supports
Use the system supports when cutting pipes. This will
ensure safe working and optimum results. Work on flat
surface. Place the pipe on two supports so that the
cutting point is between the supports. Place two more
support under both ends of the pipe. Check that all
support wheels contact the pipe (adjust if required e.g.
with pieces of lumber) (FIGURE B1). When cutting
short and light weight pipes, place the supports so that
the cutting point is outside supports (FIGURE B2).
Support the pipe with your left leg, if required. Proper
arrangements will prevent the blade from jamming as
the pipe is cut through.
Attaching the pipe saw to the pipe
Open the pipe saw's gripper unit enough to suit the
diameter of the pipe by rotating the adjustment handle
located at the rear of the saw (FIGURE C / 1). Position
the pipe saw on top of the pipe so that the edge of the
lower blade guard is at the cutting mark. Fasten the
pipe saw to the pipe by turning the gripper adjustment
handle until the gripper grips firmly the pipe to be cut
(FIGURE C / 2).
Lock the mechanism by tightening the gripper locking
collar (FIGURE C / 3). Hold the pipe in place and
ensure that pipe saw moves freely in the direction the
pipe is fed. For sake of safety ensure the pipe saw
power cable is to the left of the pipe saw. The pipe saw
is now ready for cutting.
FIGURE B1
FIGURE B2
FIGURE C