Manual primeTOUCH flat Series
08.12.2020
Page
11
of
26
5.3 Electrical setup
Note: This user’s manual is an addendum to the standard user’s manuals of
the basis NEC LC displays listed in 4.3 Specifications. Read the corresponding
original manual carefully before starting the electrical set up of the
primeTOUCH flat product.
1. Connect the NEC display like described in the corresponding original NEC manual to
power and PC. The assignment of the different models can be found in chapter 4.3
Specifications.
WARNING: Electrical work shall only be done by a fully qualified and trained
electrician. Follow the local laws and regulations.
If you want to use the remote control of the display, for example to set the correct image
source, please note that the infrared receiver is barely visible, it is located at the bottom-
right part of the screen (viewed from front, red circle in Figure 2).
Figure 2: Position of IR receiver
2. To set up the touch function connect one end of the included USB cable A-male/A-male
to the USB port (A-female) at the lower right corner (backside view, red circle in Figure 3)
of the primeTOUCH flat overlay and connect the other end to your PC.
