EWM PM 301 W, Руководство по эксплуатации

Страница: 23 / 59

Design and function
Transport and installation
099-700003-EW501
14.09.2020
23
5.2.9.2 Component management on the welding torch
The Xnet component management software can be used to manage components, create welding se-
quence plans and assign WPS. The display shows seams and runs. After completion they can be ack-
nowledged with the burner. A temporary exit (free-welding mode) from the seam sequence is possible by
pressing a key on the torch.
The following illustration is an example of use:
C D
B A
B
B
B
Figure 5-7
The arrow key on the right can be used to acknowledge welding beads. To enter the submenu, hold
button for 3s. After 3s without selection, the component mode is displayed again.
The free-welding mode is activated via the arrow key on the left of . Press and hold button 3s. The
display shows a symbol. Free-welding mode for e. g. tacking is now activated. Pressing and holding
repeatedly will get you back to component mode.
The keys and allow the navigation of the seams and runs. Long pressing of the button skips to the
last not yet acknowledged weld bead.