Machine description – quick overview
Operating the machine control
099-007033-EW501
4.1.2022
23
4.4.6 Welding data display
The following welding parameters can be displayed before (nominal values), during (actual values) or af-
ter welding (hold values):
Parameter
Before welding
(nominal values)
During welding
(actual values)
After welding
(hold values)
Welding current
Parameter times
Parameter currents
Frequency, balance
JOB number
Welding power
Welding voltage
When the hold values are displayed after welding and the settings are then changed (e.g. welding cur-
rent), the display will switch to the relevant nominal values.
The parameters that can be set in the machine control function sequence are dependent on the welding
task selected. This means that if no pulse variant was selected, for example, no pulse parameters will be
available to set in the function sequence.
4.4.7 Setting the welding current (absolute/percentage)
The welding current for the ignition, secondary, end and hot start current can be set as a percentage of
the main current AMP or as an absolute value. To select the display use the parameter
in the config-
uration menu
> see 5.9 chapter
.
