Instruction Booklet
REMO AUTO-FLEX
•
Press the power switch to get the scooter on power
standby (red light on), then press and hold both
acceleration [ ] / deceleration [ ] buttons for 2
seconds. The panel light will be all on when scooter
is ready for backlight setting. (Figure 9)
•
Press [ ] to increase level of backlight. Press [ ]
to decrease level of backlight.
•
Press the power switch to save the backlight setting
•
Panel backlight can be adjusted under power standby mode (red light), user doesn’t have
to unlock the scooter.
10
•
Press the power switch, the power (red light) will be
on standby for you to unlock.
•
To unlock, enter your password on the number pad (D),
light indicator (C) will light up each time when the number
is entered. Press (E) on the pad when password entering
is finished. (Figure 7)
•
The power light will turn green when the scooter is
successfully unlocked.
Digital Unlock Your Scooter
：
Factory Default Password : 1234
If there is enter error, press the (E) key or power switch button again to re-enter
the password.
•
Once scooter is unlocked (power green light on), press and hold the (E) key for 3 seconds,
the pad light will be flashing three times.
•
Enter your password on number pad (D), the password can be 1-4 digits number, digits
can be repeated. Light indicator (C) will light up each time when the number is entered.
•
Press (E) on the pad when password entering is finished, pad light will be flashing three
times.
Password Setting
：
If there is enter error, press power switch button again or wait for 30 seconds to
re-enter the password. Scooter must be unlocked before reset the password. If
you forget the password, please unlock the scooter by RF sensor key.
Figure 7
(C)
(D)
(E)
•
Press the power switch, the power (red light) will be
on and standby for you to unlock.
•
To unlock, place the RF sensor tag to the panel (spot
near power switch for best reading result) ( Figure 8)
•
The power light will turn green when the scooter is
successfully unlocked.
RF Sensor Unlock Your Scooter
：
•
The sensor transmit is up to 20mm, however,
please keep the distance between RF sensor
and panel as close as possible.
•
Do not dissemble the RF remote, the inner sensor chip may be damaged.
•
Do not turn off the power while unlocking the scooter, no matter it’s Digital Unlock
or RF Sensor Unlock. User will need to turn the power back on and re-unlock
again if unlocking is interrupted.
•
Scooter cannot be operated unless it’s unlocked (green light on).
Figure 8
Panel Backlight Adjustment (Five levels)
：
Figure 9
