13
6.0 In s ta llation an d in itial o p eration
Authorized personnel
The installation and initial operation may only be conducted
by qualified personnel.
WARNING
Risk of injury and material damage due to incorrect installation of
the accessories
Therefore:
• Optional devices may only be installed in accordance with their
respective instructions.
6.1 Installation location
• To determine the proper location for the actuator, adhere to
the technical data (⮑ 11 Appendix, page 28).
• Install in a location where the actuator is not exposed to
strong UV radiation or corrosive or explosive air media.
6.2 Inspections prior to
initial operation
• Performed by professional electrician.
Prior to the initial operation, a professional electrician must
perform and document the following tests and readings:
• Check visual condition
• Function check of operating features and safety features
NOTE
See additional information concerning inspections and readings
(⮑ 8 Maintenance, page 22).
6.3 Installation
• Installation is to be performed by trained personnel.
WARNING
Risk of injury and material damage due to loosening or
removal of the screws on the device
Removal or loosening of the screws on the linear unit may lead to
injuries and material damage during the operation.
Therefore:
• Never loosen or remove screws on the linear unit.
6.0 Installation and initial operation
The CASM Linear actuator (⮑ Fig.6) is attached to two ele-
ments via the push tube and the mounting accessories.
1. Assemble the motor onto the linear unit if the product is
not premounted (⮑ 7.5 Installation instruction CASM
inline kit, page 16; ⮑ 7.6 Installation instruction
CASM parallel kit, page 19).
2. Tighten the rod clevis or rod eye (2) on the rod lead.
Fig.6
NOTE
Use the wrench flat on the piston rod for counter holding.
3. Bolt the mounting accessories to the actuator (⮑ 4.3.1
accessories overview, page 10).
4. Secure elements of the application in which the linear
actuator will be installed.
5. Connect the rod end (2) and the mounting accessories
(1) and the elements of the application with the fastening
bolts (⮑ Fig.7).
Fig.7
2
2
1
