700 P electronics module
Installation
5.
61
3
Wire the A&C-Board in accordance with wiring diagram Chap-
ter 9. “Wiring Diagrams”.
4
Make sure that all cable glands are installed correctly.
5
Refit the housing cover of the 700 P electronics module.
Tighten the housing screws to a maximum torque of 0.7 Nm
(± 0.15 Nm).
6
Install CAN connection cable to the flow cell and 700 P elec-
tronics module (see Chapter 4.1 “CAN interface”).
7
Then switch on the 700 P electronics module. See Chapter 5.6
“Commissioning”.
5.6
Commissioning
Attention!
Risk of injury or damage to the device!
To ensure safe and correct commissioning, knowledge of the op-
eration, connected electrical load, measurement signals, cable as-
signment and fuse protection of the connected devices and
machines and the relevant safety regulations is required.
Start-up of the 700 P electronics module may therefore only be
performed by qualified and authorized electricians.
Incorrectly connected systems can be damaged, possibly irrepa-
rably, or cause faults in other equipment when they are switched
on or in operation. Ensure that the measuring and control cables
are not confused or make contact with one another. Never connect
or disconnect any cables to which voltage is applied.
Warning!
Risk of injury or damage to the device!
When connecting the 700 P electronics module to the power sup-
ply, a 6A back-up fuse must be used in the main supply line.
Содержание WALLACE & TIERNAN 700 P
