EVOnet VDVF430IR, Руководство пользователя

Страница: 13 / 62

Part 1 – Introduction
13
1
Alarm In/Out
IDVF320IR / VD320IR / IDVF430IR / VDVF430IR
• Out : Connect an alarm out device's mechanical or
electrical switch to the alarm out port and the GND
(ground) connector. (Supported Types: Active Low
(open collector output), Electrical Specs: 30mA
sync current at 5 VDC)
• In : Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type)
→
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect alarm
input from an electrical switch, the signal must be
higher than 4.3V from an NC switch or less than
0.3V from an NO switch and must last for longer
than 0.5 seconds.
2
Audio In/Out
IDVF320IR / VD320IR / IDVF430IR / VDVF430IR
•
Out
: Connect an amplifier to this port (line out).
This device does not feature a built-in audio
amplifier unit and therefore requires the user to
purchase a separate speaker system with a built-in
amplifier.
• In : Connect an audio source to this port. (line in)
3
Video Out
•
CVBS (Video Out) & GND (Ground)
: Connect
the cable's signal line and ground line to these
ports and the connector on its opposite end to a
monitor. Use these ports for previewing video and
not monitoring video. Go to Remote Setup (
Video
>
Camera
>
Miscellaneous
) and choose a video
out signal. (NTSC or PAL)
4
Power
• DC12V +/- : Connect the two wires of the power
adapter to these ports. Be careful not to cross
the + and - wires. Booting will commence once
connected to a power supply.
•
FGND (Frame Ground)
: Used to ground the
device.
ID420-FFIR4 receives power via PoE (Power over
Ethernet) and is therefore incompatible with
DC12V power sources.
5
Network LED
Indicates the network connection status. For more
information, refer to the
LED Status Indications on
page 14. If the
Status LED
option under
System >
General
has not been enabled, this LED will remain
turned off regardless of the network connection
status.
6
Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
INIT operation manual ,
7
Power LED
Indicates the system's operating status. For more
information, refer to the
LED Status Indications
on
page 14. If the Status LED option under System >
General has not been enabled, this LED will remain
turned off regardless of the system's operating status.
When inserting an alarm in/out, audio in/out, video
out, or power connector, hold down the button and
push the connector in through the exposed hole.
(Alarm in/out and audio in/out apply to
IDVF320IR
/ VD320IR / IDVF430IR / VDVF430IR
models only)
Release the button and then gently pull on the wire to
ensure a secure connection. To disconnect, press down
on the button again and pull the wire out.