Evolution RAGE 2, Инструкция по эксплуатации

Страница: 19 / 22

19
www.evolutionpowertools.com
FR
ES
EN
(6) MAINTENANCE
(6.1) Note:
Any maintenance must be carried
out with the machine switched off and
disconnected from the mains/battery
power supply.
Check that all safety features and guards are
operating correctly on a regular basis. Only use
this machine if all guards/safety features are
fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication
is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
wArNING:
Do not attempt to clean by
inserting pointed objects through openings
in the machines casings etc. The machines
air vents should be cleaned using
compressed dry air.
Excessive sparking may indicate the
presence of dirt in the motor or worn
out carbon brushes.
(>6.2)
If this is suspected have the machine
serviced and the brushes replaced by
a qualified technician.
(<6.2)
TrANSPOrTATION/STOrAGE
For ease and convenience, when transporting
or storing the machine, the Cutting Head can
be held in the ‘down’ position.
To hold the Cutting head down:
• Lower the Cutting Head
to its lowest position.
• Hook the requisite link of the Lock Down
Chain over the Lock Down Pin.
(6.4) ENVIrONMENTAL PrOTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice