Evo VEGA 3000 C, Руководство пользователя

Страница: 27 / 31

VEGA 3000 C/M/P Full Guide
27
Transaction list consumes the 1cm of print
roll paper per transaction, in the case of a
large number of transactions it can take more
paper (over 2 meters for a maximal limit of
200 transactions). If the paper runs out during
transaction list printing after the close batch,
the journal is not completely printed, however,
is deleted from the terminal. Reprint is possi-
ble from backup only (if this function is active).
Network settings
The Networks settings menu serves to deter-
mine the status of the network and enables
to set up network communication.
Network (LAN, Mobile data, Wifi) info
Displays information about the currently used
connection, including status, network type,
signal strength, the IP address and other
specific information.
Change connectivity
Enables you to switch between networks, e.g.
between LAN, WiFi or Mobile. The menu
always offers only the type of networks to
which it is possible to switch.
Settings
Enables to specify parameters for different
types of networks.
GPRS
Enter APN (for example “Internet”) and PIN
for the SIM card used.
WiFi
Displays a list of available WiFi networks and
allows to select required network. After the
network is selected the WiFi password is
entered via the terminal keyboard.
After confirming the password, the terminal
saves network settings and connects to the
selected WiFi network.
Note: Entering characters of WiFi password:
Use the keypad to enter characters. Write the desired
character by repeated pressing of the appropriate key.
It is possible to write both, uppercase and lowercase
lettters. Example: By pressing the key “2” you can enter
these characters: 2 A B C a b c. Write the character
“B” by pressing 3x the key “2”. Special characters can
be found under the “0” key. A correction (erasing the
last character) is made by pressing the key “Correct”.
Diacritics are not supported.
Restore connection
Restarts network connection module. Used
in case the connection is lost and does not
reconnect automatically.
Factory reset
Resets the network settings (connection)
to the default setting for the terminal. It is
used when troubleshooting the network
connection.
Software update
Terminal checks whether it uses the latest ver-
sion of SW or configuration. If the software or
configuration of the terminal is not up-to-date
the new version of software or configuration
is downloaded and the terminal is updated.
After the update the terminal restarts.
Terminal
This function is used for changes in the ter-
minal settings. Operations in this menu are
reserved for technicians only. Entering this
menu is protected by a password.