EVGA Z270 Stinger (111-KS-E272)
- 48 -
PLEASE FULLY READ THE INSTRUCTIONS THAT COME WITH
YOUR M.2 or PCI-E NVMe SSD BEFORE INSTALLATION
.
2.
After reviewing your SSD’s instructions and its respective Physical installation
instructions above, power on the PC and enter the BIOS/UEFI by pressing
the F2 key repeatedly.
3.
Once in BIOS/UEFI, navigate to the “BOOT” section. Then go down to the
“CSM Configuration” heading and press enter, or click on it with your mouse.
a.
For Windows 10 / 8.1: Set “Launch Storage OpROM Policy” to
“UEFI”. Then set “Launch CSM” to “Disable”.
b.
For Windows 7: Windows 7 does **NOT** have native support for
NVMe, and limited UEFI support. In Windows 7, “Launch CSM” has
to remain enabled, but set “Launch Storage OpROM Policy” to
“UEFI”.
4.
Press F10 to save and exit the BIOS/UEFI.
5.
Press Del on reboot to reenter BIOS/UEFI.
a.
If you are using a SSD-attached via PCI-E, proceed to Step
6
.
b.
If you are using the motherboard’s M.2 slot, proceed to Step
8
.
6.
If you are using a SSD connected via PCI-E (e.g. an Intel 750) or through an
adapter that connects a M.2 SSD to PCI-E, go to “Advanced – PCI-E
Configuration” and verify that the device shows on the slot you have it installed.
a.
Verify the lane count and PCI-E Generation. It should state “x4
Gen3”.
7.
Next check the Dashboard on the upper right. The populated slot, lanes used,
and PCI-E Generation should all match the information found in the previous
step.
a.
Proceed to Step
9
when done.
8.
If you are using a SSD connected to the motherboard’s M.2 slot, re-enter the
BIOS/UEFI and go to “Advanced – Onboard Device Configuration,” and set
“M.2 Socket3” to “Enable.”
9.
Go to the “Boot” Section, set “Boot Mode Select” to UEFI, and set first boot
device to “Hard Disk:Windows Boot Manager”.
10.
Press F10 to save and exit. Insert/Connect your Operating System install
media and reboot.
11.
Begin the Windows installation. During the drive selection step, you may need
to load additional drivers that are provided by the SSD’s manufacturer, which
would be covered in the SSD manual. If these steps are not followed you will
likely be unable to install the Operating System to the SSD and make it
bootable.
Содержание Z270 Stinger
