EverRide Hornet EZYN2048S, Руководство оператора и каталог запасных частей

Страница: 46 / 110

LUBRICATION AND MAINTENANCE - 38
4. Clean and inspect the bearings. Replace the
bearings if needed.
NOTE: The bearings are press fit. Be
sure to press only on the outer race.
5.
Reinstall the 5/8 flatwasher, 5/8 lockwasher,
spiral washer and secure in place using the
5/8 hex nut removed prior.
6. Reinstall the cap.
LEVELING THE DECK
CAUTION: Stop the engine, put the mo-
tion control arms in the park position
and remove the key from the ignition
before performing any maintenance or
repairs on this unit.
1. Set the front tire pressure to 20 p.s.i. and the
rear tire pressure to 12 p.s.i.
2. Place the mower on a level surface.
3. Raise the mower deck to the highest position
and adjust the cut height to 3 inches.
4. Lower the deck back to cut position.
5. Set both of the outside blades to be perpen-
dicular to the mower as shown.
A B
6. Measure the height of the blade tips on both
A and B and adjust the front adjustment bolts
and the rear U-bolts to insure the deck is level
from left to right.
7. Rotate the mower blades so they are parallel
to the mower deck. Use the rear adjustment
bolts to adjust the deck so that the rear blade
tip is 1/8” higher than the front blade tip on the
same blade.
Measure the blade heights to make sure they
match what is shown on the height of cut dial.
The height is measured as the distance between
the ground and the bottom of the blade. If the
blade height does not match the dial height, see
Synchronizing Height of Cut.
SYNCHRONIZING HEIGHT OF CUT
CAUTION: Stop the engine, put the mo-
tion control arms in the park position
and remove the key from the ignition
before performing any maintenance or
repairs on this unit.
NOTE: It is necessary to insure the deck
is level before synchronizing the height of
cut dial with the deck blade height.
1. Raise the mower deck to the highest position.
Take the weight off of the deck lift linkage by
inserting wood blocks under each corner of the
deck and slowly lowering it until it is resting on
the blocks.
2. Loosen the 1/2 jam nut (4) from the 1/2 adjust-
able yoke (2). Pull the 1/2” clevis spring pin (5)
out of the adjustable yoke. If the blade height
is higher than the height of cut dial, tighten the
yoke onto the 1/2-13 x 4.5” bolt which runs
through the height of cut index arm weldment
(4). If the blade height is lower than the height
of cut dial, then loosen the yoke on the 1/2-13
x 4.5” bolt.