EverRide Hornet EZYN2048S, Руководство оператора и каталог запасных частей

Страница: 45 / 110

37 -
LUBRICATION AND MAINTENANCE
6. Move the control lever rearward and release
the control lever. This control lever should
return to a position where the control lever
can be swung outward and lock in the neutral
outward position.
7. After both sides have been adjusted, the
handles can be aligned by loosening the
hardware on the handles in the locations
shown below.
3. Remove the lock nut, bolt and wheel assembly
from the wheel fork assembly.
4. Remove the bushings, bearings and the spacer
tube from the wheel assembly.
5. Clean and inspect the bearings and pack with
clean grease. Replace bearings as needed.
6. Install the spacer tube, bearings, and new
seals.
7. Install the wheel assembly using the bolt and
locknut removed in step 3.
SERVICING THE CASTER PIVOT
BEARINGS
SERVICING THE CASTER WHEEL ROLLER
BEARINGS
1. Park the unit on a level surface, put the motion
control arms in the park position, turn off the
engine and remove the key.
1. Park the unit on a level surface, put the motion
control arms in the park position, turn off the
engine and remove the key.
2. Raise the front of the power unit and support it
with jackstands.
2. Raise the front of the power unit and support
it with jackstands.
3. Remove the cap (2), the 5/8 hex nut (8), the 5/8
flat washers (10) and lock washers (9), spiral
washers (3) and the front wheel weldment
(7).
2
8
10
9
3
4
6
4
7
�� � � � � �� � � � � � �� � �
12
1
5
13