EverRide Hornet EZYN2048S, Руководство оператора и каталог запасных частей

Страница: 28 / 110

OPERATING THE POWER UNIT- 20
Dead
Battery
+
Helper
Battery
Engine Block
Or Frame
-
-
+
IMPORTANT: DO NOT leave the key
in the ignition while the machine is unat-
tended.
Jump Starting The Power Unit
WARNING: Battery gases can be ex-
plosive. Keep all cigarettes, sparks or
flames away from the battery.
WARNING: If the battery is frozen, do
not attempt to jump start the engine.
WARNING: Do not connect the nega-
tive battery cable to the power unit
battery.
IMPORTANT: This mower has a 12-volt
negative ground starting system. Use only
helper vehicles with the same voltage. Use
of a higher electrical voltage vehicle to
jump this machine could result in damage
to the electrical system.
1. Pull the helper vehicle close enough for easy
connection to the battery.
WARNING: Do not allow the vehicles to
touch when attempting a jump start.
2. Put the mower motion control arms in the park
position and put the helper vehicle in the neutral
position and apply the parking brake. Turn the
engine off.
3. Put on safety goggles and rubber gloves.
4. Raise the seat and seat plate and attach the red
clamp to the red pole (po) on the dead
mower battery. This clamp should lie parallel
with the tractor frame. Attach the other red
cable to the red pole (po) on the helper
vehicle.
5. Attach the other black cable to the black
(negative -) pole on the helper vehicle.
6. Connect the black cable to the mower frame or
engine block for a ground. Connect this as far
from the mower battery as possible.
7. Start the helper vehicle and let it run for a short
amount of time. Lower the seat to make sure
the positive cable end does not come into con-
tact with the seat plate and start the disabled
mower.
WARNING: Do not allow the seat plate
to touch the jumper cables when at-
tempting a jump start.
8. Disconnect the cables in the exact reverse
order. Start with step 6, then 5 and 4.
IF THE ENGINE DOES NOT START
If the engine fails to start:
1. Wait until the engine comes to a complete stop
before you attempt to start it again to avoid
starter motor damage.
2. Wait at least 30 seconds before you attempt
to start the engine again to allow the battery
voltage to recover and to avoid starter motor
damage.