EverRide Hornet EZYN2048S, Руководство оператора и каталог запасных частей

Страница: 27 / 110

19 - OPERATING THE POWER UNIT

Check engine and hydraulic reservoir oil and
replenish as necessary.

Check the pump belt and drive belt tension and
adjust as necessary.

Insure air intake screens are clear of debris to
provide maximum engine cooling.

General inspection of tires, tire pressure and
wheel bolt torque. Observe for external signs
of leakage and correct before operating the
mower. Check motion control arms for loose-
ness and correct position.

Check for adequate fuel supply. It is recom-
mended that the fuel tank be replenished fol-
lowing each days use to reduce condensation
and provide a full tank for next use.
WARNING: Carefully read and un-
derstand the SAFETY section of this
manual.
WARNING: Always start and operate
the engine in a well ventilated area. If
in an enclosed area, vent the exhaust
outside.
WARNING: Do not modify or tamper
with the exhaust system.
Normal Starting
CAUTION: Do not attempt to start the
engine unless you are seated in the
operator’s seat. Do not allow anyone
on the mower except the operator.
DANGER: Only use the key switch to
start the engine.
CAUTION: Never use an engine starting
aid such as ether. Engine damage will
result.
Sit on the operator’s seat. Be sure the handles
are both facing out in the park position and the
PTO is not engaged.
Set the engine speed control to the slow posi-
tion.
Turn the key from OFF to RUN. Check that all
indicators are normal. This will automatically ac-
tivate a glow plug timer. An indicator light will go
out when properly heated.
NOTE: The glow plugs are used to as-
sist starting in cold weather conditions. If
the engine is being operated in normal or
warm weather conditions, the engine may
be started without first heating the glow
plugs.
Turn the key clockwise to the START position.
Release the key as soon as the engine starts. It
will return to the RUN position.
CAUTION: Never hold the key in the
START position for longer than 15
seconds or the starter motor will over-
heat.
NOTE: Because of safety features, the
engine can’t be started unless the control
arms are in the park position, the operator
is in the seat, and the mower PTO is off.
Allow the engine to idle for a few minutes before
increasing the RPM or engaging the PTO.
Use the engine speed lever to increase and de-
crease the engine speed. Moving the lever forward
will increase the engine speed while moving the
lever backwards will lower the engine speed.
Before turning off engine disengage the PTO, put
the handles in neutral, and pull the engine speed
lever back to a low idle. Allow the engine to idle
for a few minutes and then turn the engine off by
turning the key left to the off position. Be sure to
remove the key before getting out of the operator’s
seat.