Everlast POWER i-MIG 200E, Руководство оператора

Страница: 22 / 24

22
NO. PARTS QTY
1 Diffuser D.12 14 - 15AK 1
2 Contact Tip 0.8/M6*25 1
3 15AK Goose gun neck assy. 1
4 Adapter for goose neck 1
5 Plastic adapter 1
6 MIG gun handle 1
7 Torch switch 21.8mm 1
8 Screw D.3*10 3
9 Handle locking ring 1
10 Articulating joint 15AK 1
11 Coaxial cable assy /16mmq/3m 1
12 Cable thimble 12 - 16 - 25 MMQ 1
13 CO
2
Euro - rear connector handle 1
14 Retaining Screw M4*6 UNI 6107 1
15 Knurled locking nut 1
16 Euro - main connector 1
17 Securing nut for gas input 1
18 Insulating feed pipe 0.6 - 0.8 3m, Blue 1
19 Contact Tip Wrench 1
NOTE: Over time, pressure on the drive rolls causes metal fragments from the filler wire ’ s surface to find its way to the
gun cable liner. If the wire guide is not cleaned, it can gradually clog up and causes wire feed malfunctions. If feeding
difficulty is observed, clean the liner in the following manner
：
1) Remove the welding gun ’ s gas nozzle, contact tip and contact tip ’ s adapter.
2) With an air nozzle below compressed air through the wire guide. Wear eye protection!
3) Blow out the wire feed mechanism and reel housing with dry compressed air.
4) Reassemble components. Tighten the contact tip and contact tip ’ s adapter to spanner tightness.
The MIG torch liner may eventually become worn and will need to be replaced. When welding aluminum, a Teflon liner
must be used, necessitating a liner change. A spool gun is the preferred method to weld Al. To change the liner:
1) Remove the securing nut of the liner (#17) which exposes the end of the wire guide.
2) Straighten the gun cable and withdraw the liner from the gun.
3) Carefully push a new wire guide in to the gun. Make sure that the wire guide travels all the way to the contact tip.
4) Make sure the O - ring at the machine - end of the gun is installed
5) Tighten the wire guide in place.
6) Cut the liner 2mm from the mounting nut and file the sharp edge of the liner.
7) Reattach the gun and tighten all parts.
8) Re - thread wire.
TO INSTALL MIG GUN/TORCH:
A. Align pins on with the feeder receptacle.
B. Fully engage the connector into the receptacle.
C. Twist knurled nut (#15) on connector until the nut is snug.
DO NOT OVERTIGHTEN! USE HAND PRESSURE ONLY.
NOTE: Some components may appear slightly different as design/
supplier changes are made from time to time. At time of publication,
the standard torch provided with this unit is the Trafimet Ergo Plus 15.
Setup Guide and Component Identification Section 2
EXPANDED VIEW OF MIG TORCH