Customer Service 1-888-707-1880
Or email [email protected] Dyaco Canada Inc.© 2015
- 7 -
ASSEMBLY INSTRUCTION
This manual is designed to help you easily assemble, adjust and use this machine. Please read
this manual carefully. For the sake of familiarizing yourself with the parts identified in the
instruction, first study the overview drawing.
Set all parts in a clear area on the floor and remove the packing material. Refer to the parts list for
help to identify the parts. It will take two people to assemble your unit.
It will take two people to assemble your unit.
Note: If a part is not in the hardware kit, check to see if it has been preassembled. To avoid
damaging parts, do not use power tools for assembly.
STEP 1
1) Cut the zip tie (82) between handlebar (65) and monitor support bracket (9).
3) Pull and slide the handlebar (65) and pass through the monitor support bracket (9) and
monitor bracket (11) carefully as shown.
4) Rotate the handlebar (65) to right 90
∘
and rest onto the handlebar stand (86) in position.
NOTE: Please follow the following step to assemble handlebar and avoid the chain to
drop off from the pivot shaft.
Use left hand to hold the chain (66) which is located on gear of pivot shaft and right hand
grips handlebar (65) through the monitor support bracket (9) & monitor bracket (11),
and place handlebar (65) on stand (86).
5) Put the top welded bracket of front stabilizer (6) with two wheel caps (28R/L) to bottom
four screw holes of front main frame (1) and tighten with four cap nuts (29), four spring
washers (114) and four flat washers (77).
6) Attach
“U” support bracket (2) to the end “U” welded bracket of front main frame (1) and
tighten with two allen head bolts (107), two flat washers (77), two spring washers (114)
and two nylon nuts (76).
NOTE: After finish whole product assembly, you can screw the pre-assembled level knob
(27) to adjust the whole product balance.
65
1
1
2
9
82
1
29
77
114
1
6
107
114
76
107
77
2
3
105
65
86
9
11
27
2
