Evergreen Ever-Lite 2010, Руководство пользователя

Страница: 40 / 51

41
SLIDE-OUT ROOM SYSTEMS
12-volt motors are used to extend and retract the slide-out rooms. It is recommended that the RV be connected to shore
power or to a tow vehicle with engine running when operating the rooms. Reduced battery power will hamper or prevent
movement of the slide room.
Transit bar for slide room
The transit bars are placed on top of the retracted slide room between the exterior wall and interior slide-out fascia. Tighten
the center bar by hand. Do not over- tighten or use a tool to tighten the bar. Note that smaller slide rooms will be provided
with one transit bar and larger rooms will utilize two bars.
Always install the slide room transit bars prior to transporting the RV. Extending the room
without removing transit bars may result in damage to the RV or a person. Damage to the RV
caused by improper use of the transit bars is not covered under any warranty.
Manual operation of the slide room
The room may be manually retracted or extended using a 5/8” wrench or socket. Locate the hexagonal shaft adjacent to the
slide motor which is located inside the RV at base of slide room. Using a 5/8” wrench turn the shaft clockwise to extend the
room and counterclockwise to retract the room.
Manual operation connection point
Slide out room tips
•
Always remove slide room transit bars prior to extension of slide room and install the slide bars after retraction of
room and prior to travel.
•
Ensure that batteries, battery terminals, and battery cables are well maintained and in optimal condition. See
maintenance section for further information as to proper maintenance techniques.