Evergreen Ever-Lite 2010, Руководство пользователя

Страница: 37 / 51

38
1. Turn off the water heater
2. Turn off the water supply (if connected to city water) otherwise, turn off the water pump.
3. Open the Pressure Relief Valve by lifting up on the lever at top of relief valve. Relief valve is to remain open
until water stops flowing. Caution: protect yourself from the hot water following from the valve as scalds and
burn could occur.
4. Allow the valve to snap closed and turn on water pump or water supply and allow the system to refill.
This procedure will allow formation of a small air pocket at the top of tank. This air pocket will assist in absorbing the
expansion of water during future uses of the water heater.
The water heater must be drained when placed in storage or when subjected to freezing conditions. A water heater failure
due to freezing is considered misuse or abuse and is not covered under any warranty.
Please see the water heater owner’s manual supplied with the RV for further operating, use, and care instruction.
WATER HEATER BYPASS VALVE
Your trailer may be equipped with a water heater bypass valve system. This is a system of three valves located at
rear of water heater accessible from inside the trailer. There will be a valve on the top (hot output) water line, a
valve at the bottom (cold inlet) in addition to one valve located between the hot and cold lines. The purpose of
this bypass system is the allow winterization of the water system without filling the entire water heater with
antifreeze.
Closed Open Open Closed
Valve position for normal use. Valve position for water heater bypass
Normal valve position
Center valve is closed with top and bottom valve open