Everglades 455 CC, Руководство пользователя

Страница: 78 / 200

78
Electrical System
6.8 DC System Circuit Protection
Power is distributed to most of the 12 volt acces-
sories through individual circuit breakers in the
digital switching control modules. Fuses located
in panels on the forward systems compartment
bulkhead protect the circuits for the remote battery
switches, battery charging circuits and continuous
power circuits. Other fuse panels below the helm
near the digital switching control modules, behind
the hardtop panel and below the upper helm protect
the circuits for other accessories not protected by
circuit breakers in the control modules
Fuses are labeled for the accessory circuit they
protect. Blank or spare fuse holders are reserved
for additional accessories not usually installed by
the factory.
If a fuse blows, it must be replaced with a fuse
of the same amperage as the original. Fuses are
labeled and color coded. Never try to correct a
problem with a 12 volt accessory by installing a
larger fuse. This could cause the accessory or
circuit with a problem to overheat, which could
result in an electrical fire.
The following is a description of the most common
circuit breakers and fuse panels. Some accessory
circuit breakers and fuses described in this section
provide protection for optional equipment that may
not be installed on your boat.
Main Circuit Breakers
DC Power is distributed to the fuse panels, helm
digital switch modules, electronics and other
main circuits through heavy duty circuit breakers
located below the helm near the digital control
modules and on the forward systems compartment
bulkhead. The circuit breakers are labeled for the
circuit they protect.
These main circuits are deactivated when the
house battery switch is off. The breakers are
supplied power whenever the House battery
switch is on.
Heavy duty breakers are equipped with a red
“push to test” button and a black or yellow reset
lever. If a circuit breaker is tripped by an over-
load, the yellow or black lever near the center of
the breaker will be visible and pointing downward.
Reset the breaker by pushing the lever until it
resets and locks in the “ON” position. The circuit
breaker can be tested for proper operation by
pressing the red test button.
Notice:
If a main circuit breaker trips, always make
sure the problem that caused the breaker to
trip is found and corrected before resetting
the breaker.
Continuous Power Fuses
These fuses are located in continuous power fuse
panels on the forward systems compartment
bulkhead and below the helm near the digital
control module.
Main Circuit Breakers, Accessory Fuse Panels & Digital Control Module on Forward Aft Systems Compartment Bulkhead
1. Continuos Power Fuse Panel 4. Main Circuit Breakers
2. Continuos Power Fuse Panel 5. Digital Control Module & Circuit Breakers
3. Accessory Fuse Panel 6. Fireboy Automatic Fire Extinguishing System
1
2
3
4
5
6
6