Everglades 2012 350 LX, Руководство пользователя

Страница: 89 / 164

89
DRAINAGE SYSTEMS
9.1 General
All water is drained by gravity to overboard thru-
hull fittings located in the hull above the water
line. It is important to check the drain system
frequently to ensure it is free flowing and that the
hoses on the thru-hull fittings are secure and not
leaking. Please review the drainage schematic
to become familiar with the location of the drain
thru-hull fittings.
9.2 Cockpit and Deck Drainage
Cockpit Drains
Your Everglades has four scupper drains located in
the rear of the cockpit below a small hatch. The
scuppers drain to thru-hull fittings in each trim tab
well to reduce the surge of seawater through the
scuppers and into the cockpit while maneuvering
or in rough water.
Water is channeled away from all hatches by a
gutter or drain rail system. The water then drains
overboard through the scupper drain system.
Work Station Sink Drains
The work station sink is drained by gravity to a
thru-hull fitting in the hull side.
Cup Holder Drains
All cup holders in the helm and cockpit areas drain
by gravity to the cockpit sole.
Rope Locker Drain
The rope locker drains overboard thru a drain
hole in the bottom of the locker. It is important
to inspect the drain frequently to remove any ac-
cumulated debris.
9.3 Hardtop and Crow’s Tower Drains
There is a hole drilled in the leg bases on the frame
to prevent water from being trapped within the legs.
Additional drain holes are drilled in the tubing to
drain other areas as required.
Always make sure the leg drain holes are clear when
the boat is laid up for the winter. Water trapped in-
side the legs could freeze and cause the legs to split.
Chapter 9:
Typical Scupper Drains and Drain Rail
Scupper Drain Thru-hull Fittings
Rope Locker Drain Fitting in Hull Side