56
5.8.3
Call M/T Seq.
Use this menu page to configure the dwell times (the
number of seconds a specific channel will be displayed)
and the order in which the camera channels will be
displayed on the Call Monitor.
The configured sequence will repeat continuously from
steps 1 through 20 until interrupted.
Step:
This number shows the position of the related
camera in the sequence – for reference.
Camera:
Select which camera will appear in this
position/step.
Dwell (sec):
Set the dwell time for each step/camera (from 0 to 99 seconds).
The configured sequence will repeat continuously from steps 1 through 20 until interrupted.
5.9
SYSTEM SETTING
On the right is a screenshot of the
SYSTEM SETTING MENU
. This menu is for setting up the general system parameters
for the DVR.
5.9.1
Date/Time
Date:
Set current Date.
Time:
Set current Time.
Date Format:
Choose date format from yyyy/mm/dd,
dd/mm/yyyy, and mm/dd/yyyy.
Time Format:
Change time format between 12H and 24H
mode.
Time Zone:
Set the time zone that the DVR adjusts to
when updating from the time server.
NTP:
Select “Enable” or “Disable” NTP time synchronization.
NTP Server:
Displays the time server address that the DVR uses for time synchronization. Requires operating network
configuration and WAN or LAN access to a compatible NTP server.
To find a compatible NTP address, please follow these steps:
a) Go to a PC that is connected to the internet.
b) Click on “START” -> “RUN” -> type “command” and press “OK”.
c) In the DOS Prompt, type “ping pool.ntp.org” to find out the IP address of an NTP Server.
NTP Update Interval:
The frequency that the system automatically updates the time via the NTP server. Select Daily,
Weekly, or Monthly.
Содержание PARAGON 264x1
Страница 1: ...User Manual P PA AR RA AG GO ON N2 26 64 4x x1 1 1 16 6C CH H D DV VR R...
Страница 73: ...66...
