0
GF0600055RevA06, October 006
Everest Lite Owner's Manual
adjust seat height
bolt
nut
knob
seat
post
sEAt
Remove seat
1. Engage the drive wheels (with the drive engagement
levers) and turn wheelchair power off.
2. Disconnect the hand control connector from the cowl
connector, as shown at right.
3. Pull the seat rotate lever while lifting the seat up and off
the base to remove it, as shown at right.
Install seat
1. Pull the seat rotate lever while placing the seat on the base frame. Ensure that seat is
securely installed before continuing.
2. Connect the hand control connector to the cowl connector.
WARNING: Ensure that seat is securely installed before occupying or operating
wheelchair.
Adjust seat height
Tools needed: M5 hex key, M13 wrench
1. Remove seat: follow steps 1-3 in preceding
Re-
move seat
section.
2. Loosen knob to free seat post.
3. Use M5 hex key and M13 wrench to remove nut
and bolt that secure seat post.
4. Move seat post to desired position.
5. Reinstall hardware. Use M5 hex key and M13
wrench to tighten.
6. Tighten knob to secure seat post.
WARNING: Ensure that seat is securely installed before occupying or operating
wheelchair.
